Picking a carbon filter for grow tent ventilation sounds simple until you see the numbers: 4, 6 or 8 inch, 195 or 388 or 725 CFM, and a tent that might have only a couple of ports big enough for the duct. The filter, the inline fan and the ducting all have to match, and the tent has to physically fit them. This guide walks through how to size the set for your tent, using VIVOSUN’s published specs for its AeroZesh fan kits and carbon filters. Once the light is chosen, see our 2×4 grow light guide, because the light is what the fan has to keep up with.
How to Size a Carbon Filter and Inline Fan for a Grow Tent
Sizing comes down to four checks, in this order:
- Tent volume. Multiply width, depth and height in inches and divide by 1,728 to get cubic feet.
- Fan airflow (CFM). A common starting rule is to choose a fan that could move the tent’s volume in about a minute at its maximum rating. That’s a rule of thumb, not a VIVOSUN spec. Most growers then add margin, because filters, bends and long duct runs all reduce real airflow, and a fan that is too small can’t be fixed by turning it up.
- Duct diameter. The fan, the filter and the ducting need the same diameter: a 4-inch fan goes with a 4-inch filter and 4-inch duct, and so on.
- Filter rating. Pick a filter whose rated airflow is at least as high as the fan’s maximum, so the filter isn’t the bottleneck.
Here is how that works out for VIVOSUN’s tents. The volumes come from each tent’s listed size, and the fan pairing is the one VIVOSUN lists as recommended on each tent page. The last column is our arithmetic: the fan’s maximum rated airflow divided by the tent’s volume.
| Tent | Size (W x D x H) | Volume | Duct ports (size x count) | VIVOSUN’s recommended fan | Fan max CFM vs. volume |
|---|---|---|---|---|---|
| 2×2 | 24 x 24 x 48 in | 16 cu ft | 4″ x 2, 6″ x 3 | AeroZesh T4/G4 | 12.2x |
| 4×2 (2×4) | 48 x 24 x 72 in | 48 cu ft | 4″ x 2, 6″ x 6, 8″ x 1 | AeroZesh T4/G4 | 4.1x |
| 3×3 | 36 x 36 x 72 in | 54 cu ft | 4″ x 2, 6″ x 6, 8″ x 1 | AeroZesh T4/G4 | 3.6x |
| 4×4 | 48 x 48 x 80 in | 107 cu ft | 4″ x 2, 6″ x 2, 8″ x 5 | AeroZesh T6/G6 | 3.6x |
| 5×5 | 60 x 60 x 80 in | 167 cu ft | 4″ x 2, 6″ x 2, 8″ x 4, 10″ x 1 | AeroZesh T8/G8 | 4.4x |
Every recommended pairing is well above a once-per-minute exchange. That headroom matters because you’ll rarely run the fan flat out, and because a hot light or a humid room can ask a lot of it. A bigger fan on a speed controller is usually easier to live with than a smaller fan running at its limit.
Hollywood’s tip: Before you buy, check the ports on your tent. A 2×2 tent from VIVOSUN has 4-inch and 6-inch ports but no 8-inch one, so an 8-inch fan kit wouldn’t connect to it without an adapter.
Carbon Filter for Grow Tent Kits: Sizes Compared
VIVOSUN sells its AeroZesh inline fans bundled with a carbon filter and ducting. The specs below are from its G-series kit pages, checked in November 2026, and the filter figures are from its standalone carbon filter pages. Prices change often, so check them on VIVOSUN’s site.
| 4-inch kit (G4) | 6-inch kit (G6) | 8-inch kit (G8) | |
|---|---|---|---|
| Fan max airflow | 195 CFM | 388 CFM | 725 CFM |
| Fan power | 20 W | 35 W | 78 W |
| Fan speed | 2600 RPM | 2500 RPM | 3000 RPM |
| Noise (spec table) | 39 dBA | 45 dBA | 51 dBA |
| Filter rated airflow | 264 CFM | 455 CFM | 850 CFM |
| Filter size | 11.8 x 6.9 in | 15.7 x 8.9 in | 19.7 x 10.9 in |
| Carbon grade | 1200+ IAV, Australian virgin RC412 | 1200+ IAV, Australian virgin RC412 | 1200+ IAV, Australian virgin RC412 |
| Ducting included | 8 ft | 8 ft | 25 ft |
| Fan size | 11.6 x 8 x 6.7 in | 11.6 x 8 x 6.7 in | 11.6 x 8 x 6.7 in |
The fan and filter are paired correctly at each size: 195 CFM against a 264 CFM filter, 388 against 455 and 725 against 850. One thing to know about noise: on some listings the bullet text quotes quieter figures than the specification table (for example 28 and 32 dBA for the 4 and 6 inch models). We use the specification table, and you should treat any noise number as approximate until you hear the fan in your own space.
See VIVOSUN inline fan and carbon filter kits →
Fan Controller: E12 or GrowHub E42A+?
Each size comes with a choice of controller. The kits with the E12 speed controller give you ten PWM fan speeds and remember the last speed after a power cycle. The kits with the GrowHub E42A+ add a temperature and humidity probe, VPD readings and app control, so the fan speed can respond to the tent. Both fans are variable speed (VIVOSUN calls them PWM-controlled), which is what lets you run a large fan quietly.
If you only need a fan you set and forget, the E12 does the job. If you want the fan to react to conditions, or you plan to run a humidifier and light from one place too, look at VIVOSUN GrowHub controllers.
What to Buy Along With Your Carbon Filter
- Ducting and clamps: a kit includes ducting, but a longer run or a different layout may need more. VIVOSUN sells ducting, clamps and tent vent covers.
- Noise-reduction clamps: VIVOSUN lists 4, 6 and 8 inch clamps with a rubber coupler that are meant to cut vibration and noise where the duct meets the fan. They’re on the inline fan page.
- A prefilter sleeve: the carbon filters include a removable Velcro prefilter, and VIVOSUN sells replacements. The prefilter catches dust before it reaches the carbon.
- A hygrometer: fans can pull a room dry or let a tent run humid, so a thermometer and hygrometer shows what’s actually happening. See VIVOSUN thermo-hygrometers.
Where the Fan and Filter Go in a Tent
In the usual layout the carbon filter hangs inside the tent near the top, the fan connects to the filter’s outlet, and ducting carries the air out of the tent. VIVOSUN’s listing says the filter can also be used as an intake filter, so you can use it at either end depending on your setup. Always follow the instructions that come with your kit, and make sure the ducting is routed so that air leaves the room or area you intend. Our grow tent setup guide shows the whole layout, and Grow Tent Ventilation and VPD explains how airflow ties into temperature and humidity.
Ventilation also matters in winter, when pulling in cold air can cool the tent too far. See How to Keep a Grow Tent Warm for how to balance the two, and Cannabis Mold and Bud Rot for why stale, humid air is worth avoiding.
Frequently Asked Questions
What size carbon filter do I need for a 2×4 grow tent?
VIVOSUN’s 4×2 tent page lists the 4-inch AeroZesh T4/G4 fan as its recommended fan. The 4-inch G4 kit pairs a 195 CFM fan with a filter rated at 264 CFM. A 2×4 tent is about 48 cubic feet, so that fan has plenty of headroom.
Is a 4-inch or 6-inch fan better for a 4×4 tent?
VIVOSUN lists the 6-inch AeroZesh T6/G6 as its recommended fan for its 4×4 tent. A 4×4 tent is about 107 cubic feet, and the 6-inch G6 is rated at 388 CFM. Go to the larger size if you run a powerful light or a warm room.
Does the carbon filter need to match the fan size?
Yes. The filter, fan and ducting should share the same diameter, and the filter’s rated airflow should be at least the fan’s maximum. In VIVOSUN’s lineup the 4, 6 and 8 inch kits are each matched this way.
Do I need a speed controller for the fan?
You don’t have to run the fan at full speed, and you usually won’t. VIVOSUN’s AeroZesh fans are variable speed, and each kit includes a controller (an E12 speed controller or a GrowHub E42A+). Slowing the fan makes it quieter and lets you tune airflow.
How long does a carbon filter last?
The VIVOSUN pages we read don’t give a replacement interval for these filters, and activated carbon is a consumable that loses effectiveness over time. Keep the prefilter clean, and replace the filter if you notice odor getting past it.
Next: Best Grow Light for a 2×4 Tent · What Do You Need to Grow Indoors? · Back to the Complete Cannabis Grow Guide
Disclaimer: For adults 21+ and educational purposes only. Grow only where home cultivation is legal, and follow your state and local rules. We make no medical claims. Product details, prices and policies are set by the seller and can change, so check the seller’s page before you buy.

